美国TEKNOR Apex 电线电缆 Elexar EL-1164A TPE 电线料 TPE塑胶原料 顺隆塑胶原料有限公司 TPE塑胶原料的特点： 特性备注：地下电缆、 电缆护套、电器导线护套材料、电器导线绝缘材料、电线电缆应用、电线护套、工业电缆绝缘材料、连接器、软线护套、终端电缆护套材料 重要参数： 熔体流动速率:3 g/10min 密度:1.18 g/cm3 拉伸强度:15.2 MPa 断裂伸长率:550 % 硬度:56 美国TEKNOR Apex 电线电缆料 Medalist MD-115 TPE General   Material Status  Commercial: Active Availability  Africa & Middle East Asia Pacific Europe Latin America North America Uses  Appliance Wire Insulation Appliance Wire Jacketing Cable Jacketing Connectors Flexible Cord Jacketing Industrial Cable Insulation Terminal Cable Jacketing Underground Power Cable Wire & Cable Applications Wire Jacketing Appearance  Opaque Forms  Pellets Processing Method  Extrusion Injection Molding   ASTM & ISO Properties 1 Physical Nominal Value Unit Test Method Specific Gr*ity 1.18 g/cm ASTM D792 Melt Mass-Flow Rate (MFR) (200°C/5.0 kg) 3.0 g/10 min ASTM D1238 Elastomers Nominal Value Unit Test Method Tensile Strength (Break) 15.2 MPa ASTM D412 Tensile Elongation (Break) 550 % ASTM D412 Hardness Nominal Value Unit Test Method Durometer Hardness (Shore D) 56   ASTM D2240 Processing Information Injection Nominal Value Unit   Rear Temperature 199 to 216 °C   Middle Temperature 213 to 221 °C   Front Temperature 221 to 227 °C   Nozzle Temperature 221 to 229 °C   Processing (Melt) Temp 221 to 229 °C   Mold Temperature 25.0 to 65.6 °C   Injection Pressure 1.38 to 6.89 MPa   Injection Rate Moderate-Fast     Back Pressure 0.172 to 0.345 MPa   Screw Speed 50 to 100 rpm   Cushion 3.81 to 25.4 mm   Injection Notes Drying is not necessary. However, if moisture is a problem, dry the pellets for 2 to 4 hours at 150°F (65°C). Extrusion Nominal Value Unit   Cylinder Zone 1 Temp. 193 to 210 °C   Cylinder Zone 2 Temp. 199 to 216 °C   Cylinder Zone 3 Temp. 213 to 221 °C   Cylinder Zone 5 Temp. 221 to 227 °C   Die Temperature 221 to 229 °C   Extrusion Notes Screw Speed: 30 to 100 rpm 标签： 电缆护套 TPE耐 插头料   电缆护套 TPE耐寒料 插头料   东莞市电线料tpe   东莞市电线料tpe厂家

[电缆护套 TPE耐寒料 插头料] 东莞市电线料tpe厂家
美国TEKNOR Apex 电线电缆 Elexar EL-1164A TPE 电线料 TPE